Using Detergents; After Finishing Work - Stihl RE 95 Gebrauchsanleitung

English
► Adjust the fan-jet nozzle so that the surface to be cleaned
is not damaged.
► Move the spray attachment evenly along the surface to be
cleaned.
► Move forward slowly in a controlled manner.

11.4 Using detergents

Detergents can improve the cleaning effect of the water. The
supplied STIHL spray set must be used.
► Dose and use detergents as described in the instruction
manual for the detergent.
► Fill the bottle (1) with maximum 500 ml of the detergent.
► Screw the spray nozzle (2) onto the bottle (1) and tighten
firmly by hand.
58
► If a nozzle is attached to the spray lance (3): Remove the
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water before cleaning
► Press the spray gun trigger and spray the detergent onto
► Apply the detergent starting at the bottom and working up
► Remove the spray set.
► Attach the nozzle.
► Clean the surface.
2

12 After Finishing Work

1
12.1 After finishing work
► Switch off the pressure washer and pull the mains plug out
► If the pressure washer is connected to the water supply:
► Press spray gun trigger.
► Lock spray gun trigger.
► Disconnect pressure washer from the water supply.
► Remove water hose.
3
4
nozzle
them.
the surface to be cleaned.
and do not allow to dry.
of the socket.
Turn off water tap.
The water pressure is released.
12 After Finishing Work
500 ml
400 ml
300 ml
200 ml
100 ml
0458-815-9621-A