Factory Defaults - Cameo CLMHRGB25W Bedienungsanleitung

oPeRaTion:
SeLeCTing dmX mode
Use this function to set the light to either the 6-channel or 11-channel mode.
Press the MODE button ("Addr" will appear in the display) and then use the
UP and DOWN buttons to select the DMX mode selection function ("CHMO"
will appear in the display). Now press the ENTER button and use the UP but-
ton to select the 6-channel mode (06CH) or DOWN to select the 11-channel
mode (11CH) and confirm with ENTER.
FiXTURe Time
Using this function, the fixture time can be displayed.
Press the MODE button and then use the UP and DOWN buttons to select
the fixture time display ("F l t l" appears in the display). Now press the
ENTER button. The display shows the number of hours for which the unit has
already been in operation.
ReSeT
Use this function to start the motor reset process.
Press the MODE button and then use the UP and DOWN buttons to select
the reset function ("r E s t" appears in the display). Now press the ENTER
button. The rest process begins and after approx. 20 seconds the motors are
recalibrated and the unit is operational.

FaCToRY deFaULTS

You can use this function to reset the unit to the factory default settings.
Press the MODE button and then use the UP and DOWN buttons to select
"LOAd". Now press the ENTER button. All settings (microphone sensitivity,
reverse display...) have now been reset to the factory defaults. The unit is
immediately operational again.
noTe
If one of the 4 buttons is not pushed, the LED display switches off automatically
after approx. 70 seconds. As soon as one of the four buttons is pressed, the
display switches on again automatically. In DMX mode, the display blinks as
soon as the light no longer receives a DMX signal.
11