Assembly; Unpack Contents; Unfolding The Cabin; Inserting The Wheels - QERIDOO Speedkid1 Benutzerhandbuch

Assembly

Below you can read all the information that you will need to assemble your
Make sure that you have sufficient space to assemble it. Also pay attention to the door width
at the place of installation: The Speedkid1 is 77 cm wide with the wheel guards fitted and the
Speedkid2 is 87 cm wide.
Perform each of the instructions step by step.
»
If necessary, follow the QR code to call up a video about assembly and
»
operation on the Internet.
You can find our video tutorials on our YouTube channel
»
http://vt-sk.qeridoo.de
Danger!
Never perform assembly work if there are children in the cabin. Keep children
away from the vehicle during assembly.
When handling moving components, make sure that your hands or fingers do not
get trapped. Before first use, check all screw and plug connections for tightness.

Unpack contents

Remove the packaging material and all protective caps, and dispose of them
»
in accordance with the environmental guidelines that apply in your region.
Cut the zip ties at the rear of the cabin
»

Unfolding the cabin

Place the collapsed cabin in the assembly area.
»
Stand in front of the cabin and hold the tube of the
»
rear roof rack with one hand.
Open the cabin by draging the tube upwards.
»
Hold each of the side tubes of the folding system
»
by the lower part of the hinge.
Press both hinges down until they engage audibly.
»
50 – 12 | 2020 – Subject to change without notice.
Assembly

Inserting the wheels

Speedkid properly.
»
»
»
»
»
»

Installing the wheel guard

The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars or
similar obstacles.
»
»
»
»
Speedkid
Remove the black rubber caps from the ends of the thru-axles and then dispose of them.
Lift the cabin a little bit in order to install the wheel easier.
Insert one wheel into the cabin's axle retainer:
– Hold the wheel so that you can press your
thumb onto the rubber cap on the outside of
the wheel hub.
– Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
– Insert the wheel's push-in axle as far as it will
go into the axle retainer.
– Release the rubber cap to secure the push-in
axle.
Pull on the wheel to check that the wheel is locked
in the axle retainer.
Insert the second wheel in the same way.
Danger!
After mounting the wheels, secure the Speedkid whenever you park it so as to
prevent it from rolling away, see „Applying the hand parking brake" on page 57.
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 3 bar).
If necessary, use an air pump for car valves to top up with air.
Make sure that the slide covers for the wheel guard
are fixed and tightened on both sides.
Slide the wheel guard onto the slide holder as
shown in the picture.
Be sure that the fixing mechanism locks audibly.
Repeat the procedure on the other side of the
trailer.
Tipp!
If the attachment is a little more difficult, loosen the screws by one turn or use
penetrating oil. The screws must then be tighten the screws again.
Speedkid
Subject to change without notice. – 12 | 2020 – 51