Description Of The Device; Symbols On The Device; Preparation; Initial Startup - Kärcher T 8/1 L Originalbetriebsanleitung

 This device is suitable for commercial use, e.g.
cleaning buildings (offices, hotels, etc.), for work-
men on construction sites, for carpenters and for in-
terior construction.

Description of the device

Illustration A
Fleece filter bag
1
Suction hose port
2
Suction hose
3
Carrying belt
4
Hose holder
5
Carrying handle
6
Fastening eyelets for carrying belt
7
Mains cable
8
Suction head
9
Suction head lock
10
Dirt receptacle
11
Main switch
12
Floor nozzle
13
Suction pipe
14
Suction pipe holder
15
Cable clips
16
Type plate
17
Angle piece
18
Main filter basket
19
Motor protection filter
20

Symbols on the device

Dust class
WARNING: This device contains dusts that are harmful
to your health. Emptying and maintenance, including
removal of the dust bag, may only be performed by ap-
propriately trained personnel wearing suitable personal
protective equipment. Do not switch on until the entire
filter system is installed.
Fleece filter bag, main filter basket
Fleece filter bag
Order number
Main filter basket
Order number
1. Unpack the device and install the accessories.
Illustration B
WARNING
Danger from dust that is harmful to your health
Respiratory sicknesses through inhalation of dust.
Do not vacuum without a fleece filter bag and main filter
basket, otherwise a danger to health from increased
fine dust emission is present.
ATTENTION
Fine dust entry
Risk of damage to the suction motor.
Never remove the fleece filter bag and the main filter
basket when vacuuming.
The device is fitted with a fleece filter bag, order number
6.904-084.0 (10 pieces).
Note
All types of dust up to dust class L can be vacuumed
with this device.
Note
The device is an industrial vacuum cleaner for vacuum-
ing dry, non-inflammable dusts with workplace limit val-
ues (AGW) greater than or equal to 1 mg/m
1. Check whether the fleece filter bag and the main fil-
ter basket are inserted in the device.
Installing the filter bag
1. Unlock and remove the suction head.
2. Remove the main filter basket.
3. Fit the fleece filter bag.
4. Insert the main filter basket.
5. Fit and lock the suction head.
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
1. Perform cleaning.
Switching off the device
1. Switch off the device at the main switch.
2. Pull out the mains plug.
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of the device and
clean with a moist cloth.
English
6.904-084.0
2.889-099.0

Preparation

Initial startup

Operation

Cleaning mode
3
.
9