Conrad HSA9001A Bedienungsanleitung Seite 42

Example:
You want to set a temperature of 22°C for Mondays 5:30 a.m.
At 8:30 a.m., you want the temperature to fall to 18°C.
Proceed as follows to make the settings:
• Hold down the "PROG" button for about 4 seconds to activate PROGRAMMING
mode. "Pro" is displayed.
• Press the "PROG" button once to go to setting mode. "- - - -" is displayed.
• Use buttons "UP" and "DOWN" to select Monday ("Mo" is displayed in the top
left-hand corner).
• Press the "PROG" button. "SP1" is displayed.
• Press the "PROG" button. You are now in the settings menu for the activation
time of switch-point 1.
• Use buttons "UP" and "DOWN" to select 5:30 as the activation time.
• Press the "PROG" button. You are now in the settings menu for the temperature
of switch-point 1.
• Use buttons "UP" and "DOWN" to select a temperature of 22°C.
• Press the "PROG" button. "SP2" is displayed.
• Press the "PROG" button. You are now in the settings menu for the activation
time of switch-point 2.
• Use buttons "UP" and "DOWN" to select 8:30 as the activation time.
• Press the "PROG" button. You are now in the settings menu for the temperature
of switch-point 2.
• Use buttons "UP" and "DOWN" to select a temperature of 18°C.
• Hold down the "PROG" button for about 3 seconds to save the settings and quit
programming mode.
• Hold down the "AUTO" button until the
left-hand side. Now AUTOMATIC mode is
active (this only applies if programming mode was activated from MANUEL
mode).
To additionally define switch-points for Tuesdays, proceed as described in the pre-
ceding example. Of course you can define more than 2 switch-points (max.
4 switch-points).
symbol is displayed on the
41