Initial Operation - Bosch PDO 6 Bedienungsanleitung

When the battery indication a in the display lights up, measuring is
possible for approx. 1 h when using alkali-manganese batteries (serv-
ice life is shorter with rechargeable batteries). When the battery indi-
cation a flashes, measuring is still possible for approx. 10 minutes.
When the battery indication a and the illuminated ring 1 (red) are
flashing, measuring is no longer possible and the battery or the
rechargeable battery respectively, must be replaced.
If the measuring tool is not used for a long period of time,
the battery must be removed. The battery can corrode or dis-
charge itself over long periods.
Operation

Initial Operation

Protect the measuring tool against moisture and direct
sun irradiation.
Switching On and Off
Before switching the measuring tool on, make sure that
the sensor area 5 is not moist. If required, wipe the measur-
ing tool dry using a cloth.
If the measuring tool was subject to an extreme temper-
ature change, allow it to adjust to the ambient tempera-
ture before switching on.
To switch on the measuring tool, press the On/Off switch 4.
After a brief self-check, the measuring tool is ready for operation.
The operational readiness is indicated by a check mark behind the
"AutoCal" calibration indicator d.
To switch the measuring tool off, press the "on/off" button 4.
When no measurements are carried out for approx. 10 minutes, the
measuring tool switches off automatically in order to extend the serv-
ice life of the batteries.
14 | English
1 609 929 K82 • 17.1.07