Inserting/Replacing The Battery; Initial Operation - Bosch PLR 25 Originalbetriebsanleitung

OBJ_DOKU-27422-001.fm Page 17 Thursday, July 14, 2011 11:09 AM
Digital Laser Rangefinder
Weight according to EPTA-Procedure 01/2003
Dimensions
Degree of protection (excluding battery com-
partment)
A) The working range increases depending on how well the laser light is reflected from the sur-
face of the target (scattered, not reflective) and with increased brightness of the laser point to
the ambient light intensity (interior spaces, twilight). In unfavourable conditions (e.g. when
measuring outdoors at intense sunlight), it may be necessary to use the target plate.
B) In unfavourable conditions (e.g. at intense sunlight or an insufficiently reflecting surface),
±
the maximum deviation is 7 mm per 25 m. In favourable conditions, a deviation influence of
±
0.05 mm/m must be taken into account.
C) In the continuous measurement function, the maximum operating temperature is +40 °C.
D) Less measurements are possible when using 1.2 V rechargeable batteries than with 1.5 V
batteries.
Please observe the article number on the type plate of your measuring tool. The trade names
of the individual measuring tools may vary.
The measuring tool can be clearly identified with the serial number 18 on the type plate.
Assembly

Inserting/Replacing the Battery

Using alkali-manganese or rechargeable batteries is recommended for operation
of the measuring tool.
Less measurements are possible when using 1.2 V rechargeable batteries than
with 1.5 V batteries.
To open the battery lid 15, press the latch 14 in the direction of the arrow and
remove the battery lid. Insert the batteries/rechargeable batteries. When insert-
ing, pay attention to the correct polarity according to the representation on the
inside of the battery compartment.
When the battery symbol appears for the first time on the display, at least
100 measurements are still possible. When the battery symbol flashes, the bat-
teries/rechargeable batteries must be replaced; measurements are no longer
possible.
Always replace all batteries/rechargeable batteries at the same time. Do not use
different brands or types of batteries/rechargeable batteries together.
Remove the batteries/rechargeable batteries from the measuring tool
when not using it for longer periods. When storing for longer periods, the
batteries/rechargeable batteries can corrode and discharge themselves.
Operation

Initial Operation

Do not leave the switched on measuring tool unattended and switch the
measuring tool off after use. Other persons could be blinded by the laser
beam.
Protect the measuring tool against moisture and direct sun light.
Do not subject the measuring tool to extreme temperatures or variations
in temperature. As an example, do not leave it in vehicles for longer periods.
In case of large variations in temperature, allow the measuring tool to adjust
to the ambient temperature before putting it into operation. In case of ex-
treme temperatures or variations in temperature, the accuracy of the measur-
ing tool can be impaired.
Bosch Power Tools
English | 17
PLR 25
0.18 kg
58 x 104 x 36 mm
IP 44 (splash water protected)
2 609 140 620 | (14.7.11)