Inserting/Replacing The Batteries - VOLTCRAFT VC5070 Bedienungsanleitung

Inserting/replacing the batteries

Operation of the measuring instrument requires batteries, which are included in delivery.
Insert new batteries:
• upon initial operation,
• when the power indicator (12) does not light up any more
• when null balancing in the resistance measuring range can no longer be performed.
Proceed as follows to insert or change the batteries:
- Remove all measuring lines and turn off the multimeter.
- Remove the rubber holster from the housing.
- Loosen the housing screw on the back and carefully slide off
the battery compartment lid (11).
- Insert new batteries as displayed. Watch out for the polarity in
the battery compartment. 9V (PP3) battery + 2 AA batteries.
- Now, carefully close the housing again.
Never operate the measuring device when it is open.
!DANGER TO LIFE!
Do not leave flat batteries in the device. Even batteries protected against leaking can
corrode and thus release chemicals which may be detrimental to your health or
destroy the device.
Do not leave batteries lying around carelessly. They could be swallowed by children
or pets. If swallowed, consult a doctor immediately.
If the device is not used over a period of time, remove the batteries in order to pre-
vent leaking.
Leaked or damaged batteries can burn your skin if touched. Therefore, use suitable
protective gloves.
Make sure that batteries are not short-circuited. Do not throw batteries into fire.
Batteries must not be recharged. There is danger of explosion.
You can order suitable alkaline batteries stating the following order no.:
Item no. 65 25 09 (please order one).
Order no.: 65 25 02 (please order 2).
Only use alkaline batteries. They are powerful and long-lasting.
35