Panasonic CZ-ANC3 Einbauanleitung Seite 3

 Provide a power outlet to be used exclusively for this controller.
 Turn off the circuit breaker of the controllers before installation.
 Do not supply power to the controller until all wiring is
completed or reconnected and checked.
 Fix the power supply wiring securely with the clamper so
that the power supply terminal board part is free of tension
(external force) when pulled. Loose connection of the
terminal board may occur fi re.
 To prevent possible hazards from insulation failure, the
controller must be grounded.
 Select an installation location which is rigid and strong
enough to support or hold the controller, and select a location
for easy maintenance.
 This product must not be modifi ed or disassembled under
any circumstances.
Modifi ed or disassembled controller may cause fi re, electric
shock or injury.
 Do not clean inside the controller by users.
Engage authorized dealer or specialist for cleaning.
 Do not operate with wet hands.
 Ground yourself to discharge static electricity before
performing any wiring.
 Do not use the controller at the following locations.
• Areas where leakage of fl ammable gas may be expected
• Places where large amounts of oil mist exist
• Locations where external air may enter the room directly
(This may cause "condensation".)
• Locations where high-frequency emissions are generated
• Location where voltage fl uctuation frequently occurs
 Do not wash with water.
NOTICE
The English text is the original instructions. Other languages are translation of the original
instructions.
WARNING
CAUTION
3
(EN)