Turn On The Camera; Delete Files - Num'axes PIE1052 Gebrauchsanleitung

If you need the QR code again, you can find it as follows:
Put the camera in SETUP mode > Press MENU > Go to the Other tab > Scroll down to the QR code parameter > Press
OK and the QR code is displayed on the LCD screen.
8. Operation

8.1. Turn ON the camera

Put the switch in the ON position; the camera is ready to work (the LCD screen does not light up when you put the switch
to ON).
The indicator light located on the front of the product flashes 5 times before the camera gets into working mode.
This interval allows you time to close the camera front cover and leave the monitored area.
Once in the ON mode, the camera will take photos or videos according to its current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings.
8.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very low level. Therefore, please remove the
batteries if the camera will not be used for a long time.
The OFF mode is the "safe mode" for actions such as: replacing the memory card, replacing the SIM card, replacing the
batteries or transporting the camera.
8.3. Photo/video playback on the LCD screen
− Slide the switch to the SETUP position.
− Press  to enter playback, then press  and  for selection.
− Press OK to play photo/video.
− Press  again to exit.

8.4. Delete files

− Slide the switch to the SETUP position.
− Press  to enter playback, then press  and  for selection.
22/72 Guide d'utilisation PIE1052 – indice B – Janvier 2022
To finalize the synchronisation,
switch the camera off then on
again by setting the selector
to the OFF position and then
back to the SETUP position.
Your camera can now send the
captured photos to the cloud storage.
You can install your device in the field.
Remember to put the selector in the
ON position before you leave.