Setting The Camera In Pir Mode - Num'axes PIE 1013 Gebrauchsanleitung

programmable setting (MAN).
When the power switch is in the TEST position, the camera will power
off after 5 minutes without operation.
Setting the Preset Selection Mode
NOTE: If you choose one of the Preset settings, your camera
will only function in PIR mode (it will not function in Time
Lapse mode).
•
A (Preset A) - This bypasses all user
defined settings and uses the following
settings: PIR mode / Still image /
Resolution: 5MP / Burst: 3P (3 images
per trigger) / Time out: 30 seconds
•
B (Preset B) - This bypasses all user
defined settings and uses the following
settings: PIR mode / Video length: 10
seconds / Video resolution: 720P / Time
out: 30 seconds
Setting the Programmable Selection Mode
Your camera can be programmed to operate either in PIR Detection
mode or Time Lapse/PIR mode. When changing the settings, the switch
is in the TEST position then you have to slide it to MAN.
•
MAN - This allows the user to define what settings the camera
will use.
Passive Infrared
Mode

Setting the camera in PIR Mode

•
Slide the switch to the TEST position from OFF.
•
The status display will show the camera current status.
•
Press the [M] button once to enter the programming mode, the
word "PIR" or "TLS" will be blinking.
Indice A
Time-Lapse / PIR
Mode
38/144