How To Start The Camera - Num'axes PIE1046 Gebrauchsanleitung

Before inserting or removing the SD card, the camera must be turned off (switch in the OFF position). Failing to do
so may cause loss of or damage the files already recorded on the memory card.
When the SD card is full, the LCD screen indicates "Memory full".
5. SIM card
When the camera is in SETUP mode and no SIM card is inserted, the LDC screen displays "No SIM".
Before inserting or removing the SIM card, the camera must be turned off (switch in the OFF position).
6. Attaching the antenna
Screw the antenna onto the socket on top of the camera. Make sure it is securely attached, but do not over-tighten it.
7. USB connection
When the camera is connected via USB cable; the LCD screen displays "MSDC". Press "MENU" once, "MSDC" turns to
"PC Cam", the camera now can be used as a PC camera. Press "MENU" again, the camera exits the PC camera mode.
8. Quick start
8.1.

How to start the camera?

Put the switch in the "ON" position; the camera is ready to work upon motion triggers (the LCD screen does not light
up when you put the switch to ON).
NOTE: the camera comes pre-programmed with factory default settings. So for test purpose, you only need to insert
the SD card and AA batteries then power on the camera (switch in the ON position).
8.2. How to configure the camera settings?
− Slide the switch to the "SETUP" position (the LCD screen will light up), then press the "MENU" button once to
enter the camera setting menu.
− Use the navigation buttons "", "", "" or "" to see and change the settings, press "OK" for confirmation
and save the changes, press "MENU" to exit the current page.
− Slide the switch to the ON position to enable the camera to work on PIR.
− The indicator light located on the front of the product flashes 5 times before it gets into PIR auto working
mode.
NOTE: For some settings, you need to press "MENU" to save and exit the configuration after pressing "OK" to confirm
(Camera ID, Delay, Time Lapse, Timer, Password).
8.3. How to connect the camera to the network?
When you slide the switch to the SETUP position, the camera automatically enters a signal searching process (if a SIM
card is inserted).
PIE1046 - Indice A –Septembre 2020 20/76