Kayoba 021290 Bedienungsanleitung Seite 50

EN
Error code 22: motor control fault
Check that motor's starter lever is in neutral.
Error code 23: motor circuit fault
Check that motor is correctly connected to the
control unit and that all the connections are
intact.
Error code 24: signal fault hall sensor for
motor
For control unit without hall sensor, check that
motor is correctly connected. For control unit
with hall sensor, check that the hall sensor is
correctly connected.
Error code 25: brake fault
Check that the brakes are not applied, and
have gone fully back before switching the
display unit on.
Error code 30: communication fault
Check that all the cables between the display
unit and the control unit are correctly connected.
Settings
With the display switched on, press the buttons
+ and – at the same time for 2 seconds to go
to the settings menu. To leave the settings
menu, press the button
Setting the wheel diameter
Press the button + or – to set the correct wheel
diameter. Wheel diameter settings: 16 inch, 18
inch, 20 inch, 22 inch, 24 inch, 26 inch, 700C,
28 inch. The standard setting is 26 inch. Press
the button to confirm the wheel diameter
setting and to go to the next setting.
FIG. 8
50
for 2 seconds.
Setting the top speed limit
A top speed limit can be set for the power
assistance as a safety function. The electric
motor switches off when the speed goes
over this limit. The top speed limit can be set
from 12 to 40 km/h. The standard setting is
25 km/h. Press the button + or – to set the
required top speed limit. Press the button
to confirm the setting. Go to next setting.
FIG. 9
Setting the backlight
"bL" stands for backlight. Level 1 is low
brightness. Level 2 is medium brightness. Level
3 is high brightness. Press the button + or – to
set the required brightness. Press the button
to confirm the setting.
FIG. 10
BATTERY
1. Battery indicator
2. Button 0/1 to start (1) and switch off (0)
the battery.
FIG. 11
START CYCLING
1. Start pedalling, the electric motor starts
and assists while the pedalling continues.
2. Adjust the assistance from the electric
motor with the mode button. The power
assistance stops when the rider stops
pedalling, when the brake is used, or
when the speed reaches over 25 km/h.
3. The bike has eight gears. Change gear by
turning the inner part of the right handle
on the handlebars.
Note:
• Be careful when using the power assistance
the first time because the electric bike
accelerates faster than a normal bike.