To Bear In Mind When Riding; Riding The Bike - Kayoba 021290 Bedienungsanleitung

the brake disc goes in between the brake pads.
Fit the axle with the quick-release and fasten
the nut on the opposite side. Secure the wheel
firmly in place with the quick-release.
HANDLEBARS
Put the handlebars in the column recess, clamp
in place and tighten the four screws.
WARNING!
Do not raise the handlebars over the marking
for maximum height.
PEDALS
Screw the pedals onto the pedal arms.. Make
sure to fit them the right way round, they are
threaded in different directions so they will not
come loose. The pedals are marked with R for
right and L for left.
LIGHTS
Use good quality batteries for the lights.
USE
BEFORE USING FOR THE FIRST TIME
• The battery is half-charged on delivery.
Charge the battery for 10-12 hours before
using for the first time the next two or
three times.
• Be careful when using the power
assistance the first time because the
electric bike accelerates faster than a
normal bike.
• Ride the bike on a smooth surface first to
get used to the acceleration.
WARNING!
• This electric bike runs on a lithium-ion
battery. Never charge the battery with
any other charger than the one supplied
with the bike – risk of fire or explosion.
• Never remove the battery from the bike
when charging is in progress.

TO BEAR IN MIND WHEN RIDING

• Follow local traffic regulations.
• Wear a bike helmet.
• Be careful when braking, brake first with
the more gentle back brake.
• The power assistance works up to max
25 km/h and then switches off. When the
speed drops below 25 km/h and the rider
continues to pedal the power assistance
starts again.
• Do not use the power assistance in
slippery conditions, or on loose gravel or
clay.
• Switch off the power assistance if the
electric bike behaves "unusually" to avoid
damaging the electrical system.
• The front and back lights have two modes
– constant and flashing. Press the light
button once for constant and twice to
flash.
• Remember to switch off the bike and the
lights after use.
WARNING!
• Check that the front and back brakes are
working properly.
• Check that the front and back wheels are
properly screwed on and that there is no
play.
• Check that the pedals, saddle and
handlebars are properly screwed on and
that there is no play.
• Check that the quick-release on the
saddle is properly tensioned and that
there is no play.

RIDING THE BIKE

1. Press the power switch on the battery and
press ON on the control panel.
2. The motor is activated when you start
pedalling and assists all the time while
the battery lasts, and switches off when
braking, or as soon as you stop pedalling.
EN
47