Battery Indicator; Backlight - Kayoba 021290 Bedienungsanleitung

Starting and switching off the
display
Press the button for 2 seconds to start the
display and the control unit. To switch off the
display and the electric system on the bike,
press the button again for 2 seconds.
The display and control unit switch off.
NOTE:
If the bike is not used for 10 minutes the
display switches off automatically.
Speedometer
The speedometer can show the instant
speed, average speed and maximum speed.
The instant speed is shown automatically by
default. To switch over, press the buttons
and + for 2 seconds. The following is then
shown: instant speed (km/h) → average speed
(km/h) → maximum speed (km/h).
1. Instant speed
2. Average speed
3. Maximum speed
FIG. 3
Odometer
The odometer shows the trip distance when
the display is switched on. To switch over (trip
meter/total distance) press the button
display then shows: trip distance (km) → total
distance (km). To reset the trip meter, press the
buttons and –.
1. Trip distance (TRIP)
2. Total distance (ODO)
FIG. 4

Backlight

Press the button + for 2 seconds to switch on
the backlight. The headlight goes on at the
same time. To switch off the light, press the
button + for 2 seconds again.
FIG. 5
Selection of assistance level
Press the button + or – to adjust the assistance
power of the motor. There are five assistance
levels, 1 to 5. 1 is the lowest and 5 is full power.
The standard setting is assistance level 1. Three
examples of how the assistance levels are
shown on the display:
1. Assistance level 1
2. Assistance level 2
3. Assistance level 5
FIG. 6

Battery indicator

The battery charge is shown on the display
in five levels. FULL is shown at the top of the
battery charge indicator when the battery is
fully charged. When the battery is discharged
(low battery voltage) the letter E is shown at
the bottom of the battery indicator and the
indicator flashes. The battery must then be
charged.
1. Fully charged battery
2. Partially discharged battery
3. Fully discharged battery (the indicator
. The
flashes)
FIG. 7
Error codes
Error codes are shown automatically if there is
a fault in the control electronics. Check the part
of the bike to which the error code refers.
Error code 21: circuit fault
Check that all connections are correct,
undamaged and not short-circuited.
EN
49