Husqvarna DC 655 Bedienungsanweisung Seite 19

WARNING:
not installed correctly, dust can come
in to the air. The dust particles are
dangerous to your health.
8. Install the lock bar.
9. Install the 3 nuts. Make sure that there is no space
between the nuts.
CAUTION:
correctly installed on the screw that
holds the lock bar. Dust in the filter
housing can cause damage to the
threads on the screw.
10. Do the same replacement procedure on the other 2
rows of primary filters.
11. Install the cover of the filter housing and the 6 nuts.
To do a check of the V-belt tension
WARNING:
cover when the product is disconnected from
the mains outlet and the motor has fully
stopped.
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 11 .
2. Remove the V-belt cover.
3. Examine the V-belts for damages and wear. Replace
the V-belts if it is necessary.
2061 - 002 - 19.04.2023
If the primary filters are
The 3 nuts must be
Only remove the V-belt
Do not operate the product
To stop the product on
4. Push the V-belts with your tumb to examine the
tension. If you can push the V-belts a distance of
10–15 mm (A), the tension is correct.
5. Do the steps that follow to adjust the V-belt tension if
it is necessary
a) Loosen the 4 nuts.
b) Loosen the tension nut to increase the V-belt
tension. Tighten the tension nut to loosen the
V-belts.
c) Tighten the 4 nuts.
6. Install the V-belt cover.
To replace the V-belts
WARNING:
cover when the product is disconnected from
the mains outlet and the motor has fully
stopped.
A
Only remove the V-belt
19