Dust Container; Air Flow Hatch - Husqvarna DC 655 Bedienungsanweisung

b) Set the ON/OFF switch to the OFF position.
c) Disconnect the power plug from the power
supply.
d) Close the air flow hatch.
To adjust the suction power
Use the air flow hatch on top of the product to adjust
the suction power. It is necessary to adjust the suction
power for example when the primary filters are new.
1. Adjust the suction power between position (A) to (D)
on the air flow hatch.
C
D
B
A
a) For less suction power, use position (B) or (A).
b) For more suction power, use position (C) or (D).
Dust storage systems
The collected dust is collected at the bottom of the
product in the dust storage system. You can use the
product with different dust storage systems. Refer to
Accessories on page 25 .
To empty the dust container
WARNING:
the dust container, a full dust container can
be heavy.
12
Be careful when you empty
WARNING:
protection when you empty the dust
container. Refer to
equipment on page 6 .
1. Open the clamp locks.
2. Loosen the clamps.
3. Extend the 2 handles on the dust container.
4. Obey local regulations for disposal of the contents of
the dust container.
To discard a full BigBag and install a new
BigBag bag
WARNING:
caution, a full BigBag can be heavy. Make
sure that the cable ties are closed correctly
before you lift the BigBag.
WARNING:
protection when you empty the dust
collector. Refer to
equipment on page 6 .
Use approved respiratory
Personal protective
Lift the BigBag with
Use approved respiratory
Personal protective
2061 - 002 - 19.04.2023