Transportation And Storage; Residual Risks - Ryobi RBC1226I Originalanleitung

a thrown object as the blade begins to turn.
■
Exercise extreme caution when using the
blade with the product. Blade thrust is the
reaction that may occur when the spinning
blade contacts anything it cannot cut. This
contact may cause the blade to stop for an
instant, and suddenly "thrust" the product
away from the object that was hit. This
reaction can be violent enough to cause
the operator to lose control of the product.
Blade thrust may occur without warning if
the blade snags, stalls, or binds. This is
more likely to occur in areas where it is
difficult to see the material being cut.
■
For cutting ease and safety, approach the
weeds being cut from the right to the left.
In the event that an unexpected object or
woody stock is encountered, this practice
could minimize the blade thrust reaction.
Both hands must be used at all times to
control the product.

TRANSPORTATION AND STORAGE

■
Stop the product and allow it to cool down
before storing or transporting.
■
Clean all foreign materials from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children.
Keep away from corrosive agents, such as
garden chemicals and de-icing salts. Do
not store outdoors.
■
If a cutting blade is fitted, cover it with the
blade protector.
■
For storage, always disconnect from power
supply.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure
cause possible injury, contribute to poor
performance, and may void your
4 | English
manufacturer's
accessories, and
to do so can
warranty.
WARNING
Servicing requires
knowledge and should be performed only by
a qualified service technician. For service,
bring the product to an authorised service
centre for repair. When servicing, use only
original replacement parts.
■
Switch off and disconnect from the mains
before conducting any maintenance or
cleaning work.
■
You may only make adjustments and
repairs described in this manual. For other
repairs, contact an authorised service
centre.
■
For the replacement line, use only nylon
filament line of the diameter described in
the specification table of this manual.
■
After extending the new cutter line, always
return the product to its normal operating
position before starting.
■
After each use, clean the product with a
soft, dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■
Check all nuts, bolts and screws before
each use and at frequent intervals for
proper tightness to ensure that the product
is in safe working condition. Any part that
is damaged should be properly repaired or
replaced by an authorised service centre.
■
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.

RESIDUAL RISKS

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■
Injury caused by vibration
– Hold the product by designated handles
and restrict working time and exposure.
■
Injury caused by exposure to noise
– Wear hearing protection and limit
extreme care and