Ryobi RBC1226I Originalanleitung Seite 4

will increase the risk of electric shock.
■
Electrical power should be supplied via
a residual current device (RCD) with a
tripping current of not more than 30 mA.
■
Before every use, examine the power cord
for damage. If there are signs of damage,
it must be replaced. Always uncoil the
power cord during use; coiled cables can
overheat.
■
If you need to use an extension cable,
ensure it is suitable for outdoor use and
has a current capacity sufficient to supply
your product. The extension cord cable
should be marked with either "H05 RNF"
or H05 VV-F". Check it before every use
for damage. Always uncoil it during use
because coiled cables can overheat.
Damaged extension cables should not be
repaired; they should be replaced with an
equivalent type.
■
Do not use the product if the electric cables
are damaged or worn.
■
If the power cord or extension cable
becomes damaged during use, disconnect
from the power supply immediately. Do not
touch the electric cables until the power
supply has been disconnected.
■
Make sure the power cord is positioned so
that it cannot be damaged by the cutting
means and will not be stepped on, tripped
over, or otherwise subjected to damage or
stress.
■
Never pick up or carry the product by the
electric cable.
■
Never pull the power cord to disconnect
from the power supply.
■
Keep the power cord away from heat, oil,
and sharp edges.
■
Make sure voltage is correct for your
product. A nameplate on the product
indicates the product's voltage. Never
connect the product to an AC voltage that
differs from this voltage.
■
Make sure the switch is in off position
before disconnecting from power supply.
PREPARATION
■
Wear full eye and hearing protection while
2 | English
using the product. If working in an area
where there is a risk of falling objects, head
protection must be worn.
■
Hearing protection
operator's ability to hear warning sounds.
Pay particular attention to potential hazards
around and inside the working area.
■
Wear heavy long trousers, boots, and
gloves. Do not wear loose fitting clothing,
short trousers, jewellery of any kind, or use
with bare feet.
■
Secure long hair so it is above shoulder
level to prevent entanglement in moving
parts.
■
Before use and after any impact, check that
there are no damaged parts. A defective
switch or any part that is damaged or worn
should be properly repaired or replaced by
an authorised service centre.
■
Make sure the cutting attachment is
properly installed and securely fastened.
■
Never operate the product unless all
guards, deflectors,
properly and securely attached.
■
Consider the environment in which you are
working. Keep the working area free from
wires, sticks, stones, and debris, which if
struck by the cutter, can become thrown
objects.
LAWN TRIMMER SAFETY WARNINGS
■
Some regions have regulations that restrict
the use of the product. Check with your
local authority for advice.
■
Never allow children or people unfamiliar
with the instructions to use the product.
■
Use the product in daylight or with good
artificial light.
■
Avoid using on wet grass.
■
Do not walk backwards when using the
product.
■
Keep firm footing and balance. Do not
overreach. Overreaching can result in loss
of balance. Always be sure of your footing
on slopes. Walk, never run.
■
Do not use the product when there is a risk
of lightning.
may restrict the
and handles are