Before Commissioning; Layout - Scheppach 5901223901 Originalbetriebsanleitung

The workpiece must have a minimum height of 3
mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise
The noise values have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Excessive noise can result in a loss of hearing.
The specified noise emission values have been meas­
ured in accordance with a standardised test procedure
and can be used to compare one power tool with an­
other.
The specified device emissions values can also be
used for an initial estimation of the load.
Warning:
• The noise emission values can vary from the speci­
fied values during the actual use of the electric tool,
depending on the type and the manner in which the
electric tool is used, and in particular the type of
workpiece being processed.
• Try to keep the stress as low as possible. For ex­
ample: Limit working time. In doing so, all parts of
the operating cycle must be taken into account (such
as times in which the electric tool is switched off or
times in which it is switched on, but is not running
under a load).
7.

Before commissioning

• Open the packaging and carefully remove the de­
vice.
• Remove the packaging material, as well as the pack­
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
32 | GB
ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
• The machine must be securely installed. Therefore,
bolt it down on a workbench, machine stand or sim­
ilar. Insert 4 screws (not included in the scope of
delivery) into the holes on the fixed saw table (15).
Tighten up the screws.
96 dB(A)
• Set the adjusting screw (38) to the level of the table­
3 dB
top to prevent the machine from tipping over.
109 dB(A)
• Prior to commissioning, all covers and safety devic­
es must be mounted correctly.
3 dB
• The saw blade must be able to run freely.
• In case of previously machined wood, be aware of
any foreign bodies, such as nails or screws, etc.
• Before pressing the on/off switch, make sure that the
saw blade is correctly fitted, and that moving parts
run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
7.1 Checking the movable saw blade guard safety
device (5)
The saw blade guard protects against accidental con­
tact with the saw blade and against flying chips.
Check function
To do this, fold the saw down:
• The saw blade guard must expose the saw blade
when it is swung down without touching other parts.
• When the saw is folded up to the initial position, the
saw blade guard must automatically cover the saw
blade.

8. Layout

8.1 Mounting the sliding cross-cut mitre saw
(fig. 1/2/4)
• To adjust the rotary table (14), loosen the handle (11)
about 2 turns and press the locking position lever
(35) down.
• Rotate the rotary table (14) and pointer (12) to the
desired angle on the scale (13) and lock in place with
the handle (11).
• Press the machine head (4) down lightly. The saw is
unlocked from the lower position by pulling out the
locking pin (23) from the engine mount.
www.scheppach.com