Assembling The Appliance - Silvercrest SPM 220 A1 Bedienungsanleitung

Assembling the appliance

NOTE
► Before first use, clean all parts of the appliance
as described in the section Cleaning.
1) Set up the appliance on a flat surface near a
mains socket that is easily accessible. There
should be enough space in front of the appli-
ance for a bowl or similar to catch the pasta.
2) Push the dough container t into the appliance
base 5 as far as the stop. The tabs on the
dough container t must be pushed into the
corresponding slots in the rear wall.
3) Guide the kneading hook 9 into the dough
container t from above and insert it into the
drive shaft 6.
4) Push the support q into the end of the
bracket w so that the three tabs on the
support q slide into the grooves on the
bracket w (fig. 3).
9
w
q
0
Fig. 3
5) Mount the bracket w onto the dough
container t. Push in the bracket w so that its
narrow end goes through the round opening
on the dough container t (fig. 3).
SPM 220 A1
The bracket w only fits into the opening in one
position; the marking e must point towards
the symbol on the dough container t.
Turn the bracket w clockwise until the
marking e on the bracket w points to the
symbol (fig. 4):
w
Fig. 4
6) Then push the dough shaft 0 with its narrow
end through the bracket w into the retainer
on the kneading hook 9 (fig. 3). If necessary,
reach into the dough container t from above
and wiggle the kneading hook 9 a little until
you can push in the dough shaft 0.
7) Place the front panel z onto the dough
container t and push it firmly into place. The
catches on the front panel z must slide into in
the corresponding recesses on the dough
container t.
8) Select the appropriate shaping disc 8 (see
section Shaping discs) and slide it onto the
bracket w so that the two catches on the
shaping disc 8 slide into the recesses on the
bracket w.
9) Push the shaping disc fixture r onto the
bracket w and tighten it by turning it clockwise
towards the symbol. Fix the shaping disc 8
in place with your free hand if necessary.
10) Do not fit the lid 2 until after you have placed
the required amount of flour in the dough
container t (see section Making pasta).
11) Insert the plug into an easily accessible mains
socket. You will hear a beep and the display a
lights up briefly. The appliance is now in
standby mode.
The appliance is now assembled and ready for
operation.
e
GB │ MT │
39 ■