For The Safety Of Your Child; Material Damage; Unpacking And Setting Up; Operating The Appliance - Silvercrest SKMP 1200 A2 Bedienungsanleitung

RP100104-105590 Küchenmaschine LB4 Seite 6 Donnerstag, 12. Juni 2014 12:50 12

4.6 For the safety of your child

Warning! Children are often
unaware of danger and are injured
as a result. Please note therefore:
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.

4.7 Material damage

Warning! Follow the instructions given
below to prevent material damage.
• Only place the appliance on a level,
dry, non-slip surface to stop the appli-
ance falling over or sliding off.
• Do not place the appliance on top of a
hot stove.
• Do not use the blender jug 12 and the
mixing bowl 16 at the same time. This
might overload the appliance.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see "1.2 Scope of supply" on
page 2) and are undamaged.
3. Clean the appliance thoroughly before
using it for the
"8. Cleaning the
page 15).

6.1 Assembling the appliance

1. Press the unlock lever 6 and swing up
the drive arm 1.
6
• Never use the mixer and the blender
• The mixer should only ever be operated
• Only ever use the blender jug 12 with
• Do not move the appliance if food or
• Only use the blender jug 12 to mix
• Do not overfill the mixing bowl 16 or
• Never add hot or boiling food to the

5. Unpacking and setting up

4. Place the appliance on a level, dry, non-
5. Check that the speed controller 4 is set
6. Put the plug in a suitable socket (see
first time (see
appliance" on
The appliance is now ready to use.

6. Operating the appliance

jug 12 when empty. This might cause
the motor to overheat.
for max. 10 minutes at a time, and the
blender for 3 minutes. Afterwards the
appliance must be first allowed to cool
down to roomtemperature again.
the lid in place 11 as liquid might other-
wise be ejected.
pastry is still inside.
drinks or make dressings.
blender jug 12 as the contents might
otherwise be ejected.
blender jug 12.
slip surface so that the appliance can
neither fall over nor slide off.
to "0".
"3. Technical data" on page 3).
Note: Press the unlock lever 6 round
fully and hold until the drive arm 1 is
right down. Then swing the unlock
lever 6 back again.