ISC RAD Bedienungsanleitung Seite 8

Important
Please read and understand these instructions before use. This product should only be used by trained &
competent operatives, or under the supervision of such a person.
Use
The RAD is a multi-function rope adjustment device and adjustable rope lanyard. Examples of its potential
uses are:
• Descender/ lowering device
• Belay device for climbing/ mountaineering, etc
• Adjustable rope lanyard for work positioning, eg. pole strop or stretcher attachment
• Progress capture in a haul system
• Temporary anchor point around a structural member
• Rope adjustment in a work restraint system
It is the user's responsibility to ensure that any items of PPE or other equipment used with the RAD are
compatible and do not interfere with the safe function of any other component. Any item of equipment
used must comply to the relevant standard(s).
Note: The information in this guide meets the requirements of the EU PPE Regulation 2016/425 . It is not
comprehensive and cannot be substituted for the correct training, which can be provided if required. If in
any doubt, contact ISC using the supplied information.
Specifications
When tested with SAR 11mm Low Stretch Rope & Rescue & Access Rope (16 plait kernmantle), the
average static load before slippage was 4.5kN. Weight of RAD device: 302g
Safety
The safety provided by the RAD is dependant on the scenario, the anchors used and the skill of the user.
The strength and suitability will be reduced through factors such as, but not limited to, age, wear & tear,
abrasion, cuts, high impact loads, tight/sharp edges, knots, some chemicals (e.g. strong acids or alkalis),
UV exposure, environment (damp or icy conditions), failure to store & maintain as recommended, etc.
The RAD will perform differently when used outside of normal climatic conditions. The user should keep
any fall factor and lanyard length to a minimum at all times. An appropriate connection method must
always be used between the harness and the anchor or system. The user must consult the instructions
for any other components used in a fall protection or fall arrest system and must pay attention to
information including fall clearance distances, etc. This device must not be used for fall arrest.
A rescue plan should always be in place prior to any work at height. Do not alter or repair the product in
any way. Any component subjected to a dynamic loading should be examined and discarded if there is any
sign of defect, or any doubts about its safety.
Lifespan
The lifespan of any product will be affected by the conditions in which it is used and stored/ maintained.
This product is manufactured using high grade aluminium alloy & stainless steel components. The rope
lanyard is either polyamide or polyamide/ polyester mix. Textile components should be retired no later
than 10 years after the Date of Manufacture. Metal components will have an indefinite lifespan, depending
on use. The working life will be reduced through general wear and tear, abrasion, cuts, damage to
component parts, inappropriate ancillary equipment, high impact load, prolonged exposure to UV light
including sunlight, elevated temperature (50° C max), exposure to some chemicals (e.g. strong alkalis)
or failure to store and maintain as recommended. This list is not exhaustive.
8
RAD: Issue C - November 2022