Operation - Klarstein AQUEOUS Bedienungsanleitung

EN
28

OPERATION

Turning the appliance on and off
1. Connect the appliance.
2. Run water through the cold and hot water outlets until the water starts to
bubble.
3. To switch on the cooling system, press the COLD button. Then the cooling
indicator starts flashing. When the cold water is available, the indicator lights
up constantly. Press the COLD button again to deactivate cooling.
4. To switch on the heating system, press the Hot water button. The heating
indicator starts flashing. When the hot water is available, the indicator lights
up continuously. Press the hot water button again to deactivate the function.
5. To turn on the appliance, press the HOT/ICE/COLD button. When the ice cube
tray is full, the indicator lights up permanently. Press the button again to
switch off the appliance.
Dispensing cold water (#3)
Note: After connecting and switching on, it takes about 1 hour for the water to
cool down completely. As soon as the water has cooled down completely, the
cooling indicator lights up continuously.
1. Place a drinking glass or container under the cold water tap. Press the COLD
button to dispense cold water.
2. Press the COLD button again to stop dispensing cold water when the
container is full.
The output time is 8 seconds. If you need more cold water, repeat the above
procedure.