Control Panel Operation; Ice Making; Cleaning Function - Klarstein ALBARON Bedienungsanleitung

EN
POWER
SELECT

CLEANING FUNCTION

20

CONTROL PANEL OPERATION

CLEAN
indicator light
SMALL ICE
indicator light
LARGE ICE
indicator light
SELECT
button
Plug in the power, the "POWER" indicator light flashes, and the machine is in
standby mode. Press the POWER button, the "POWER" indicator light always being
on and then enter the operating state. By default, the machine enters the large
ice mode, the "LARGE ICE" indicator light always being on, and then the ice block
will be made automatically. After the ice making is completed, the deicing will be
carried out, and then the ice shoveling function will be entered, and so on.
Press the "POWER" button to start the machine, and then press the "SELECT"
button switch between the three functions of "LARGE ICE", "SMALL ICE" and
"CLEAN". To select any function, the corresponding function indicator flashes for 5
seconds,
automatically confirm and switch to this function, the corresponding function
indicator light always being on. The "SELECT" operation is invalid in standby mode.
When the indoor temperature is lower than 15 ℃, small ice is recommended.
When the indoor temperature is higher than 30 ℃, large ice is recommended.
Plug in the power, press the "POWER" button to start the machine, and then press
the "SELECT" button to switch to the cleaning function. Start up the cleaning
function and the "POWER" indicator light and the "CLEAN" indicator light are
always being on. The machine first deicing once, and then starts cleaning. Each
cleaning has 5 cycles (pumping water—pouring water) and each cycle is about
90 seconds. Do not disconnect the power supply during the cleaning. After the
cleaning, the product automatically enters the standby mode.
ADD WATER
indicator light
ICE FULL
indicator light

ICE MAKING

indicator light
POWER
button