Commissioning And Operation - Klarstein Kristall XL Bedienungsanleitung

COMMISSIONING AND OPERATION

Installation
The machine should be upright to place on the horizontal plane. To ensure the machine
ventilate normally, it is important to set 150 mm room on top, sides and back. Do not
place the machine next to the roast oven, radiate or other heat objects.
Control Panel
Buttons and Indicator Lights
Connect the power, the machine switches to standby mode, and the
screen lights. Press Start/Stop, the machine starts. The display starts
Start/
counting and the ice block icon on the left side of the time display
Stop
flashes. If you press Start/Stop again during operation, the machine
switches to standby mode.
Press this button before producing ice. The cleaning indicator lights up in
Clean
the display. Press Start/Stop to stop cleaning.
Press the S/L button to select the ice cube size. The corresponding
S/L
indicator lights up in the display.
When this indicator is lit, there is not enough water in the tank. Fill the
tank with water.
When this indicator is lit, the ice box is full of ice cubes and the machine
stops production. Remove the ice. If the ice no longer reaches the ice
bar, the machine will automatically resume production.
EN
15