Control Panel Operation - Klarstein Icefestival Bullet Bedienungsanleitung

Before/First Use of Your Ice Maker
1. During transportation, the incline angle of the cabinet should not be over 45 °C.
Do not turn the Ice maker upside down. As this may damage the compressor and
sealed system.
2. Remove all packing material and carefully check your ice maker to ensure it is in
good condition and that there is no damage to the ice maker or power cord and
plug.
3. The Ice maker should be placed horizontally on a level surface.To ensure proper
ventilation for your Ice maker allow 150mm of space at the top, the back and on
each side. Do not install the Ice maker near an oven, radiator, or any other heat
source.
4. Before using the Ice maker for the first time, please wait 2 hours after positioning it,
and keep the front lid open for at least 2hours
5. Ensure that the voltage indicated on the ice maker corresponds with the voltage in
your home.
6. Pure water is not allowed to be used on this unit, spring water is recommended.
7. Please always keep the viewing window close during ice making.

CONTROL PANEL OPERATION

Press this button to shaved ice.
Before the press of this button, please put enough
ice into the bowl and covers the bowl cover well.
Unit under ice making process if it lights up without
flash
It lights up when the ice in ice basket is full.
EN
17