Installing Accessories For Automation; Installing The Robot Adapter Cpk; Preparing The Tool - HellermannTyton Autotool CPK hybrid Automatisierungsanleitung

5

Installing accessories for automation

5 .1

Installing the robot adapter CPK

Safety
WARNING
Electrically live parts
Electric shock hazard
f Before opening the tool, switch off the power pack
and disconnect the line plug from the power
supply.
f Remove the battery where necessary.
Tools needed
• Phillips screwdriver PH1
• Allen screwdriver 2.5

5 .1 .1 Preparing the tool

The tool's handle has to be removed and the robot adapter
CPK installed in its place in order for the tool to be secured
firmly to a robot.
For sizes and weight, à "Robot adapter CPK" on
page 16.
3
f Lay tool on a soft work surface.
3
f Loosen the screws .
2
f Lift the left housing cover
f Turn the tool
over and carefully lay it open side down
3
on the soft work surface.
CPK_hybrid_Automation_instructions_106-29009_V01_01.2023
slightly and remove it.
1
Installing accessories for automation
5
4
f Loosen the screws
f Lift right housing cover
toward the rear and remove.
f Turn the tool
3
on the soft work surface.
1
2
f Disconnect the plug contacts
tool from the handle.
3
f Connect the open plug contacts in the tool
other.
f Fold the waste box
f Slacken the screw
f Ease the handle
In doing so, carefully pull the cables downwards and out.
.
4
slightly at the front, ease it
5
over and carefully lay it open side down
of the handle
6
down.
9
.
7
to the rear and remove it downwards.
8
6
7
8
9
in the
8
to each
3
8