Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Notes for the user
These instructions are very important for correct installation
of the device in automatic systems. They contain important
information and safety instructions that will enable you
to install the product properly and utilise it correctly and
economically for its intended use.
1 .1
Information about these instructions
Use these instructions only together with the
Operating Instructions of the Autotool CPK hybrid.
Last change: 08.03.2023
1 .2
Warranty
The warranty is in accordance with statutory requirements.
Warranty entitlement applies only in the country in which
the products were originally purchased. Batteries, fuses and
light sources are not covered by the warranty.
1 .3
Contact data
The manufacturer of the product described in these instruc-
tions is:
HellermannTyton GmbH
Grosser Moorweg 45
D-25436 Tornesch, Germany
Tel. +49 4122 701-0
www.HellermannTyton.de
toolsystems@HellermannTyton.de
1 .4
Copyright and intellectual property rights
The manufacturer retains the copyright to these instructions.
Under no circumstances may these instructions be repro-
duced or electronically processed, replicated or disseminated,
in whole or in part, without the prior written consent of
HellermannTyton GmbH (hereinafter referred to as
HellermannTyton).
Any breach or infringement of these stipulations will result
in liability for damages.
1 .5
Retention and dissemination of these
instructions
These instructions must be kept in the immediate vicinity of
the workplace and must be available at all times to all
operating personnel. The operating company shall inform
the operating personnel of the location of these instructions.
The operating company shall obtain replacement from the
manufacturer if these instructions are, become or are
rendered no longer easily legible.
If the products are acquired by or sold on to a third party
the following documents must be handed over to the new
owner:
• These instructions
• Documents relating to repair work
• Logs of maintenance work undertaken
CPK_hybrid_Automation_instructions_106-29009_V01_01.2023
1 .6
Target group of these instructions
These instructions must be read and complied with by every
person charged with any of the following tasks:
• Installation
• Operation
• Maintenance
• Repair
• Fault rectification
1 .7
General information
All accompanying drawings are not subject to the modifica-
tion service.
1 .8
Conventions adopted in these instructions
1 .8 .1 Classification of the precautionary notices
Precautionary notices in these instructions draw attention to
hazards associated with use of the device and indicate how
they can be avoided.
Non-compliance of any nature whatsoever can lead to acci-
dents with fatal consequences, injury or damage to property.
The precautionary notices are subdivided into three groups
according to the severity of the potential hazard:
DANGER
Text accompanied by the signal word "DANGER" indicate
hazardous situations which, in the event of non-compli-
ance with the appropriate precautions, will cause death or
severe injury.
WARNING
Texts accompanied by the signal word "WARNING" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause serious injury.
CAUTION
Texts accompanied by the signal word "CAUTION" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause slight injury.
1 .8 .2 Other notational conventions
f Indicates an instruction
• Indicates a list
; Indicates the result of an action
à This text highlight is used for cross-references.
NOTE
Texts accompanied by the signal word "NOTE" indicate
situations which, in the event of non-compliance with the
appropriate precautions, can cause damage to the tool or
the product.
Texts accompanied by this symbol contain information about
environmental protection.
Texts accompanied by this symbol contain useful additional
information.
Notes for the user
4
Werbung
Inhaltsverzeichnis
