Bandoleer Cutter Cpk; Transport, Accessories, Spare Parts And Storage; Transporting The Device; Accessories And Spare Parts - HellermannTyton Autotool CPK hybrid Automatisierungsanleitung

3 .3 .3 Bandoleer cutter CPK

The bandoleer cutter CPK cuts the bandoleer and is designed
to be integrated into the system. Compressed air extends
the cylinder of the bandoleer cutter CPK forward against
the actuator, which pushes the blade against the bandoleer
so that the bandoleer is cut. The system then moves the
bandoleer cutter back to the starting position via the reset
connection (double-acting compressed air cylinder),
à "Installing the bandoleer cutter CPK" on page 9.
4 Transport, accessories, spare parts and

storage

4 .1

Transporting the device

Always use the CPK tool case that comes with the device to
transport the Autotool CPK hybrid.
NOTE
Components not correctly packed are subject to a risk of
damage in transit.
f Do not unpack components until just before they
are going to be installed.
4 .2

Accessories and spare parts

Depending on the purchase order, the following compo-
nents can be part of the scope of supply:
Name
Autotool CPK hybrid
Power pack with control box
Robot adapter CPK
Ejector CPK
Bandoleer cutter CPK
Automation instructions CPK
4 .3

Returns

HellermannTyton is exempted from obligations set out in
§10 Para. 2 (producer obligation to take back WEEE) of the
Electronic and Electronic Equipment Act, "ElektroGesetz",
and associated claims.
CPK_hybrid_Automation_instructions_106-29009_V01_01.2023

Transport, accessories, spare parts and storage

4 .4
The operating company is under obligation to ensure that
at the end of its useful life, the tool and the components
including the accessories are disposed of in accordance with
the applicable regulations. End-of-life (EOL) disposal of
the tool and individual subassemblies and the disposal of
consumables and auxiliaries are subject in part to statutory
regulations.
The appropriate local authorities will provide detailed
information on request.
f Always dispose of packaging materials in accordance
with the currently valid materials-disposal and
environmental protection regulations.
f Always take materials, production waste and
consumables for disposal to certified collection points.
f Contact the manufacturer for advice if there is any lack
of clarity regarding disposal.
4 .5

4 .5 .1 Tool and power pack with control box

f Store the tool and the power pack in a cool, dry place.
f Avoid direct sunlight.
f Store the tool and the power pack in the tool case
provided.
f Pack the electronic components (e.g.
Autotool CPK hybrid, CPK power pack and their cables,
batteries and charger) in a shockproof manner and store
them separately from the accessories.
f Consult and comply with the appropriate data sheets
for storage of the accessories.

4 .5 .2 Cable ties and cable-tie reels

NOTE
Cable ties and cable-tie reels are not resistant against
ageing. The plastic deteriorates if storage time is pro-
longed.
Article number
f Use up cable ties promptly.
106-60000
106-00110
Storage temperature
106-00072
Relative humidity
106-00095
f Always store the cable-tie reels until needed in the bags
106-00085
in which they are supplied and make sure that the bags
remain airtight. If necessary, seal the bags with adhesive
106-29009
tape.
f Do note keep in storage for longer than 6 months.
f Never leave the packaging open for longer than 12 hours.
f Do not open the packaging until immediately before the
contents are to be used and use up all the cable ties
promptly.
f Do not expose the cable-tie reels to direct sunlight.
f Keep the cable-tie reels well away from sources of heat.

Disposal

Storage
20 °C – 23 °C
50% rel.
7