Safety Instructions For Maintenance/Troubleshooting; Notes Regarding Special Types Of Hazard - Kemper SparkTrap Betriebsanleitung

2.5 Safety instructions for maintenance/troubleshooting

Service and maintenance doors must be freely accessible at all times.
Setting up, maintenance and repair work and troubleshooting must only
be performed when the product is switched off.
Always tighten bolt connections that have been loosened during repair
work. If specified, tighten the relevant bolts with a torque wrench.
In particular, protect connections and screw connections from dirt or care
products at the beginning of maintenance/repair/care
The time frames for periodic testing/inspections stipulated or specified in
the operating instructions must be observed.
Before disassembling, mark the parts that belong together.

2.6 Notes regarding special types of hazard

DANGER
Suspended loads
Tipping or falling loads lead to severe to fatal injuries.
• Never step under suspended loads.
• Always remain outside the danger zone.
• Observe the total weight, attachment points and centre of gravity of
the load.
• Observe the transport instructions and symbols on the transported
goods.
WARNING
Health hazards caused by welding fume particles
Do not inhale welding dust / smoke! Serious injury to the lungs and
respiratory tract is possible!
Sweat smoke contains substances that can cause cancer!
Skin contact with cutting and welding fumes etc. can cause skin irritation
in sensitive persons!
Repair and maintenance work on the product may only be carried out by
trained and authorised personnel while complying with the safety rules
and the applicable accident prevention regulations.
To avoid contact with and inhalation of the dust particles, wear
disposable overalls, protective goggles, gloves and a suitable Class FFP2
respiratory protection filter mask in accordance with EN 149.
1502021-01 - 46 -
EN