Install The Grass Catcher; Install The Mulch Plug; Install The Side Discharge Chute; Set The Blade/Cutting Height - Cramer 2502886 Bedienungsanleitung

Make sure that the two handle pins are in the same position.
3.4

INSTALL THE GRASS CATCHER

Figure 4
1. Remove the mulch plug.
2. Remove the side discharge chute.
3. Open the rear discharge flap and hold it.
4. Hold the grass catcher by its handle and engage the hooks
on the rear flap rod.
5. Close the rear discharge flap.
3.5

INSTALL THE MULCH PLUG

Figure 5
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge flap.
3.6 INSTALL THE SIDE DISCHARGE
CHUTE
Figure 6
CAUTION
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge flap and hold it.
2. Line up the recesses of the side discharge chute below the
pivot.
3. Close the side discharge flap.
3.7 SET THE BLADE/CUTTING
HEIGHT
The machine can be set to different blade/cutting heights.
Figure 7
1. Pull the height adjustment lever rearward to increase the
blade/cutting height.
2. Push the height adjustment lever forward to decrease the
blade/cutting height.
3.8

INSTALL THE BATTERY PACK

Figure 8.
NOTE
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
The machine has an automatic switch function that lets the
other battery work when the first cannot operate.
1. Open the battery compartment flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery compartment.
The motor starts only when you put in the safety key.
3.9

REMOVE THE BATTERY PACK

Figure 8
1. Open the battery compartment flap
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

MOWER FUNCTIONS

In general, a lawn mower is featured with four functions
(rear bagging/ rear discharging/ mulching/ side
discharging). These functions can be converted by changing
accessory setting. Please see the following table for detail
setting.
Please be noted that functions below vary with the mower
models.
TO CONVERT
MOWER
For rear discharg-
ing
For rear bagging
For mulching
For side discharg-
ing
5
WARNING
NOTE
NOTE
NOTE
MULCH GRASS SIDE DIS-
PLUG BAG CHARGE
CHUTE
× × ×
× √ ×
√ × ×
√ × √
EN