How To Solve Errors - GSW BioStar Gebrauchsanweisung

BioStar DE-GB-FR Seite 27 Montag, 13. November 2017 10:31 10
Warning!
As soon as
emerges, remove the source of heat.
The device is not to be used again until
the error has been corrected. Only a
slight emergence of steam from
pressure regulator 3 is normal.
Error
Steam is escaping from
between the lid and the
base
No steam is coming
from the pressure
regulator
Too much steam is
coming from the
pressure regulator
The lid does not open
BioStar

8. How to Solve Errors

uncontrolled steam
Cause
Appliance not closed correctly
Sealing ring is dirty
Sealing ring is broken/worn
away
Steam is escaping from
between the lid and the base
Pressure regulator is dirty
Not enough liquid in the
appliance
Heat supply too low
Heat supply too high
Pressure regulator is dirty
There is too much pressure in
the appliance
There is negative pressure in the
appliance
Solution
Close the appliance again correctly
Clean the sealing ring
Replace the sealing ring (1 x year)
See previous error
Clean the pressure regulator
(see "7.2 Cleaning the pressure cooker" on
page 25)
Slowly cool down the appliance and fill
with at least 1/4 of the base volume
Increase the heat supply (turn the hob to a
higher setting)
Decrease the heat supply (turn the hob to a
lower setting)
Clean the pressure regulator
(see "7.2 Cleaning the pressure cooker" on
page 25)
Follow the instructions in "6.4 Opening the
pressure cooker" on page 24
Press down on the sealing ring with a
spoon handle at the side opening of the lid
and let in air
fluids
27