Standard Accessories; Battery Removal/Installation - Hitachi Koki WF 14DSL Bedienungsanleitung

CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

(1) Screw feed attachment .......................................... 1
(Assembled in main body)
(2) No. 2 Plus Bit .......................................................... 3
(Assembled in main body : 1)
(3) Sheet .......................................................................... 3
(Assembled in main body : 1)
(4) Plastic case ............................................................... 1
(5) Battery cover ............................................................ 2
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Battery
(BSL1430)
Optional accessories are subject to change without notice.
Before
charging
While
The
charging
pilot
lamp
lights or Charging
blinks in complete
red.
Charging
impossible
The
pilot lamp
Overheat
lights in
standby
green.
(2) Regarding the temperatures of the rechargeable
battery
The temperatures for rechargeable batteries are as
shown in Table 2, and batteries that have become
hot should be cooled for a while before being
recharged.
UC18YRSL
14.4 V – 18 V
0.6 kg
(BSL1840)
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Flickers
Lights continuously
Lights
APPLICATIONS
Screw driving into indoor gypsum board.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the line
is visible, as shown in Fig. 3.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 1
Table 2 Recharging ranges of batteries
Rechargeable batteries
BSL1430, BSL1840
English
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge.
(Charging will commence
when battery cools)
Temperatures at
which the battery
can be recharged
0°C – 50°C
10