Configuration; Low Voltage Shut-Down - Dometic COOLAIR SPX1200I Montageanleitung

EN
2. Route the power supply lead as illustrated.
Fig.  on page 12
a) Run the wiring loom to the battery along a route where it is protected.
b) Connect the negative lead (black) for the power supply.
c) Connect the negative lead (black) for the voltage monitor.
d) Connect the positive lead (red) for the power supply via a 40 A fuse.
e) Connect the positive lead (red) for the voltage monitor via a 2 A fuse.

8 Configuration

Before the system is first put into operation, the control unit settings can be adjusted to suit the various installation
conditions Fig. . Those adjustments must be made by the installer.
The configuration mode can still be activated if the low voltage cut-out has switched off the system and only residual
voltage is available.
Display indication
P.01
P.02
P.03
Using the configuration mode
1.
Press and hold the
2. To enter the configuration mode, press and hold the
The display shows the
P.01 and the
3. Scroll through the menu by pressing the
4. Press the
button to open the desired menu item.
5. To exit the configuration mode, press and hold the
P.01: Low voltage shut-down
The battery monitor protects the battery against discharging excessively.
If the unit is switched off by the battery monitor, it means the battery charge level is low. Avoid repeated starting or
using electrical equipment. Ensure that the battery is recharged. As soon as the required voltage is available again,
the system can be operated again.
If only the power supply voltage specified here is available to the parking cooler, the system is switched off.
20
Fig.  on page 13
Parameter

Low voltage shut-down

Unit for temperature display
Tilt sensor
button.
symbol. The parking cooler switches to the configuration mode. The display shows
symbol flashes.
Meaning
The battery monitor shuts
down the system at the volt-
age defined here.
The temperature can be dis-
played in °C or °F.
The tilt sensor can be calibrat-
ed to the inclination of the ve-
hicle roof.
button for longer than 3 s.
or button to select the desired menu item.
button for longer than 3 s to exit the configuration mode.
Factory setting
22.8 V
°C
–