Connecting The Compressor Unit To The Evaporator Unit - Dometic COOLAIR SPX1200I Montageanleitung

5.
NOTICE! Damage hazard
Ensure that the coupling halves with the copper pipes are not twisted or kinked.
Carefully unwind the connection line.
Fig.  on page 5
6. Fit the evaporator unit.
Fig.  on page 6
7. Fasten the evaporator unit from the outside.
Fig.  on page 7
Sealing and attaching the hood
1. Mount one clip.
If you wish to avoid damaging the cab's rear panel (drilling a hole), you can also fix the hood in place using a suit-
able adhesive. Observe the instructions provided by the adhesive manufacturer.
2. Mount the hood.
Fig.  on page 8
Routing the supply lines to the compressor unit
Observe the following notes when routing the supply lines:
• The installation manual for the SPX 1200C compressor unit should also be observed.
• Mount the SPX 1200C compressor unit first to enable the exact position of the compressor unit to be deter-
mined. This will save you bending the copper pipe several times to make it fit.
• Ensure that the maximum length of the supply lines does not exceed 2.1 m.
• To avoid damaging the cab's rear panel fix the clip in place using a suitable adhesive. Observe the instructions
provided by the adhesive manufacturer.
1. Shorten any supply line which is not needed by bending a curve.
2. Fasten the supply lines to the cab's rear panel using the clips.
Fig.  on page 9

Connecting the compressor unit to the evaporator unit

1. Route the connection cable in a curve out through the opening in the floor of the compressor unit.
2. Fasten the connection cable as shown.
Fig.  on page 10
Fig.  on page 11
Installing the electrical connection lines
1. Connect the unit directly to the battery.
Ask your vehicle manufacturer for the specifications of the battery.
EN
19