Stretch Open The Softbox; Connect The Unit To The Power Supply; Operating And Handling The Unit; Adjust The Angle Of Inclination - Walimex Pro 23102 Gebrauchsanleitung

WARNING
Only mount the unit on a stand that is designed for the weight and dimensions of the unit.
See technical data.
Make sure that the tripod with the mounted unit is non-tilting and non-slip.
• Loosen the fixing screw enough so that the bracket can be inserted into the mounting adapter
of a suitable lamp stand.
• Place the unit on a suitable lamp tripod. For this purpose, a 5/8 inch spigot (16 mm spigot)
mounting adapter is usually built into the lamp tripod.
• Tighten the fixing screw (8).

6.2 Stretch open the softbox

• You can stretch the softbox like an umbrella. To do this, push the inner ring of the softbox
towards the lamp holder until it clicks into place. You can attach the front diffuser to the front
of the softbox with Velcro after inserting the light source.

6.3 Connect the unit to the power supply

• Switch the unit off at the ON/OFF switch (5) to <OFF>.
• Compare local power supply with the connection values of the unit.(see Technical Data.)
• Connect the power supply unit (19) to the socket of the local mains supply (AC 220-240-
240V/50-60 Hz).
NOTICE
Compare local power supply with the connection values of the unit. If the values do not
match, please contact info@walser.de.
NOTICE
Only connect the power supply unit to a protective earthed socket.
NOTICE
After use, disconnect the unit from the local power supply by pulling out the mains plug.
7.

Operating and handling the unit

7.1 Adjust the angle of inclination

• Open the locking screw for the angle of inclination.
• Set the desired angle.
• Tighten the locking screw for the angle of inclination.
31