Removing / Inserting The Slide-In Racks; Telescopic Pull-Out Rails; Changing The Oven Light Bulb - KKT KOLBE BO8810SS Benutzerhandbuch

Care and cleaning

Telescopic pull-out rails

For cleaning the slide-in racks the telescopic pull-out rails
can be removed.
• Loosen the fixing screws with a large screwdriver and
remove the complete set.
• Only clean the telescopic pull-out rails from the outside
with commercially available cleaning agents.
Do not immerse the telescopic pull-out rails in water or
clean them in a dishwasher!
• After cleaning, put on the telescopic pull-out rails and fas-
ten them again at the bottom with the screws.
Caution!
!
The rollers must not be greased.

Changing the oven light bulb

In the lamp bulb is a particularly heat-resistant mold
(230 V, 25 W).
To replace this, proceed as follows:
• In any case disconnect the appliance from the power
supply (pull the plug or remove the fuse), because the
socket could be live.
• Unscrew the glass cover.
• Unscrew the bulb and replace it with a new one of the same
type (see figure at right).
• Screw back the cover glass.
Removing the slide-in racks
2
To make it easier to clean the side walls of the cooking cham-
ber, you can remove the slide-in racks:
• Remove accessories such as grate and baking tray.
1
• Slightly press down the slide-in rack at the clamping point (1)
and pull it away from the oven wall.
• Swing the slide-in rack inwards and unhook it at the top (2).
Inserting the slide-in racks
• Hook the rack into the holes at the top (2) and swing it
towards the side wall of the cooking chamber.
• Slightly press down the rack bar at the clamping point (1)
and push the rack towards the side wall.
• The slide-in rack must snap into place and be firmly seated.
47