Indicators - Cristec YPOWER+ 12V/16A Bedienungsanleitung

3.4.9 Indicators

The following LED indicators are visible on the front of the appliance for monitoring.
Led
Charging
LED 1 "ON"
Programming
Charging
LED 2
"CHARGING
PHASE"
When the charger saves a new configuration, the two LEDs flash blue two times
Mode LEDs
Fault
(off)
(off)
Fault
Charger is ON
Stand-by mode (see section 3.4.5)
Programming (see section 3.3)
No or poor-quality AC current
Input fuse is blown
Internal charger malfunction
Charger in BOOST phase
Charger in ABSORPTION phase
Charger in FLOATING phase
Charger in REFRESH phase
Output voltage OFF
Other faults
Charger status
OTD fault
Output fuse blown
temperature range
No output voltage
.
50