Battery Cables - Cristec YPOWER+ 12V/16A Bedienungsanleitung

Remarks:
The
The
• as soon as they are no longer under AC voltage (power off delay of 20 seconds) and the output DC network
is disconnected for an activated standby mode.
• as soon as they are no longer under AC voltage (power off delay of 20 seconds) for deactivated standby
mode.
Indeed, the charger can still be active even if the AC input has been disconnected (see 3.4.5).

3.2.3 Battery cables

Disconnect batteries before any wiring and junction of the connector.
Please check the compatibility of voltage, current and setting according to the battery type before switching ON the
charger.
Checking of the charge voltage
Before connecting the batteries to the charger, first check their polarity.
Check also the battery voltage with a calibrated voltmeter. A too low voltage value on some types of batteries shows
irreversible damage and impossibility to recharge.
Any damage due to incorrect connections will be excluded from the warranty.
The table below defines the maximum battery cable cross-section allowable for the output connector:
Model
12-16, 12-25, 24-12
12-40, 24-20, 24-30
12-60
The installer should choose the type of cable (H07-VK, MX, etc.) according to the type of application and the applicable
standards.
The DC outputs must use a PHOENIX CONTACT connector type. Unused terminals should remain unconnected.
Model
12-16, 12-25, 24-12
12-40, 24-20, 24-30
12-60
PHOENIX CONTACT connector junction
Connect from left to right: -BAT, +BAT E, + BAT 1 and +BAT 2 on all
+BAT 3 only on
• - BAT (minus set of batteries)
+BAT E (plus engine battery)
•
• +BAT 1 (plus battery set 1)
• +BAT 2 (plus battery set 2)
+BAT 3 (plus battery set 3)
•
chargers are working as soon as they are powered on (AC cable connected and powered).
chargers are stopped :
PHOENIX CONTACT connector reference
12-40, 12-60, 24-20 and 24-30 models
Maximum allowable battery cable cross-section
16mm²
16mm²
35mm²
PC 16/4-STF-10,16 BK
(CRISTEC reference 30033787)
PC 16/5-STF-10,16 BK
(CRISTEC reference 30038370)
PC35 HC/5-STF-15,00 BK
(CRISTEC reference 30037678)
models
41