Charging Curve - Cristec YPOWER+ 12V/16A Bedienungsanleitung

3.4.8 Charging curve

BOOST in ON position
With this setting, the
see section 3.3.2) + return to automatic BOOST: BOOST, ABSORPTION, FLOATING + REFRESH, REBOOST.
V BOOST: BOOST voltage (see table in section 3.3.3)
V FLOAT: FLOATING voltage (see table in section 3.3.3: voltage with no BOOST)
T BOOST: BOOST maximum duration (see table in section 3.3.3)
T ABS: ABSORPTION maximum duration (see table in section 3.3.3)
BOOST phase:
Starts up automatically when the charger is turned on if the battery is flat. The current is then at maximum output.
ABSORPTION phase:
Begins when the voltage has reached the maximum BOOST level. The current level starts falling.
These two phases combined last a maximum of TBOOST+TABS (depending on setting). If the current falls below 20% of
rated current, the FLOATING phase automatically kicks in. Duration and current intensity depend on how charged the
battery is.
FLOATING phase:
Starts after TBOOST or if output current has reached 20% of the charger's rated current. The voltage switches to the
FLOATING value and the rated current continues to drop.
REFRESH phase:
It is an automatic weekly cycle in order to optimize the battery life duration.
It will occur only after a complete recharge cycle (BOOST, ABSORPTION and FLOATING). The charger will generate
automatically a safe timed voltage step every 7 days even if REFRESH phase is off (see section 3.3.3).
charger delivers a 5-step charge curve IUoU + automatic weekly recycling ("P" button
48