Husqvarna 360BT Bedienungsanweisung Seite 9

4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
WARNING:
that follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel
is fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
is not too much fuel in the fuel tank.
The fuel expands when it becomes
hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from
the refueling area and fuel source before you
start the engine.
Note:
To see where the fuel tank is on your
Product overview (360BT) on page
product, refer to
2 and Product overview (570BTS, 580BTS) on page
3 .
1967 - 002 - 23.02.2023
Do not mix fuel for more
Obey the procedure
Make sure that there
To start the product
1. For 360BT. If the engine is cold, push the choke
lever to the closed choke position. Refer to
Symbols on the product on page 3 .
2. For 570BTS and 580BTS. If the engine is
cold, push the choke lever to the closed choke
Symbols on the product on
position. Refer to
page 3 .
3. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary
to fill the air purge bulb fully.
4. Push the start/stop switch with throttle control to
the 1/3 speed position. Refer to
throttle control/stop switch on page 10 .
5. Put the product on a flat surface on the ground.
6. Hold the product with the left hand.
CAUTION:
to hold the product.
7. Pull the starter rope handle slowly until
resistance occurs.
To operate the
Do not use your feet
9