Herunterladen Diese Seite drucken

Husqvarna 360BT Bedienungsanweisung Seite 10

Vorschau ausblenden Andere Handbücher für 360BT:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 70
8. Pull the starter rope handle quickly with the right
hand. Pull the starter rope handle again and
again until the engine starts.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
9. If the engine is cold, push the choke lever to
the open choke position gradually until the choke
lever stops.
10. If the engine is cold, let the engine operate for
2-3 minutes to become warm before operation.
WARNING:
when the engine is started and when
the product is set at idle speed. Do
not let persons to come near the
product or the blower tube.
To operate the throttle control/stop
switch
B
C
D
Apply full throttle (A).
Apply 1/3 speed (B).
Apply idle speed (C).
Stop the product (D).
To operate the product
This blower is a backpack type, and is carried
using a shoulder harness while operating. It is
operated and controlled with the handle on the
tube using the right hand.
10
Air is released
A
Operate the product at usual work hours. Obey
local regulations.
Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at
lowest position possible to prevent more noise
and dust than necessary.
Keep the blower nozzle near the ground.
Note:
Husqvarna recommends that you use
the full blower nozzle extension.
Make a note of the wind direction and operate
the product in the direction of the wind.
Use applicable garden tools to release material
from the ground.
In areas with dust, use spray equipment to wet
the area. This decreases the operation time.
After operation, keep the product in storage
vertically.
To stop the product
CAUTION:
at full speed.
1. Put the start/stop switch with throttle control in
the stop position. Refer to
control/stop switch on page 10 .
To adjust the harness
A correctly adjusted harness and product makes
operation easier.
1. Put on the harness of the product.
2. Tighten the side straps until the product is tight
against your body.
For 570BTS, 580BTS:
3. Put the waist belt around your waist.
4. Tighten the waist belt strap. Make sure that the
weight of the blower stays on your hips.
5. Connect the chest strap to the clip.
6. Tighten the strap.
Do not stop the product
To operate the throttle
1967 - 002 - 23.02.2023

Werbung

loading

Diese Anleitung auch für:

570bts580bts