Bergstrom SLIMFIT FORD F-Max H625 1848T sin spoiler Montageanweisungen Seite 15

SLIMFIT
2
Attach the EPDM 30x25 seal around the hatch gap
(see the details to cut the ends of the seal joint).
Take care: The EPDM seal must be secured to the
!
projecting edge of the hatch gap.
HOW TO CUT EPDM GASKET TO AVOID
!
WATER FILTRATION INTO THE CABIN
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
Gasket
Remove
2
Nerve
INSIDE
A
Gasket
100 mm Approx. (protection paper)
C
Gasket
15
EN
EPDM seal
OUTSIDE
15 mm
Gasket
Cabin roof
Gasket