Selecting The Weighing Unit; Weighing; Risk Of Damage - ADE PFW2 Serie Betriebsanleitung

i
– The scale will automatically switch off if it is not used for 10 minutes
and there has been no change in weight.

Selecting the weighing unit

1. Press the "On/Off" button
The display 9
2. To select the desired weighing unit, press the "UNIT" button
desired weighing unit is displayed.
The last selected weighing unit will be saved. The weighing unit selected will be
cleared if the AC adapter or batteries are removed.

Weighing

NOTICE!

Risk of damage!

Improper handling of the scale may result in damage to the scale.
– Do not overload the scale. Do not exceed the maximum weigh-
ing capacity.
– When the scale is overloaded, the error message "O-Ld" is dis-
played. In this case, remove the load from the weighing plat-
form.
i
Carefully put the item to be weighed in the centre of the weighing plat-
form.
Never exceed the maximum weighing capacity of the scale (see chapter
"Technical data" on page 50).
The scale must not be used for dynamic weighing. Adding or removing
small quantities slowly (e.g. when filling a container with liquids) can yield
incorrect measurement results.
1. Switch on the scale
2. Put the item onto the weighing platform
Ensure the item is as close to the centre of the weighing platform as possible. If
possible, ensure that the item does not protrude beyond the weighing platform. The
weight of the item on the weighing platform is shown on the display
You now know the weight of the item.
Dok./Rev.-Nr. PFW2-221122-Rev001-UM-en
10 to switch the scale
will show all indicators for approx. 2 seconds.
5 .
5 on.
11
8 .
Use
repeatedly until the
9 .
45