Getting Started; Power Off - SPL Transient Designer 4Mk2 Bedienungsanleitung

Transient Designer 4 Mk2

Getting started

Read the security advises starting on page 7.
Make sure that the mains voltage of the Transient Designer 4 Mk2 mentioned in the
specifications (page 6) corresponds to the voltage of your region.
The power switch on the back of the Transient Designer 4 Mk2 must be in the off position.
(Off = O / On = I).
Connect the supplied power cord to the power connector of the Transient Designer 4 Mk2
and to a power outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the Transient Designer 4 Mk2 must be be switched
off.
Connect your devices to the inputs and outputs of the Transient Designer 4 Mk2 using
appropriate audio cables (XLR).
Audio cables not included in the scope of delivery.
Power on
Switch on the power switch on the rear panel of the Transient Designer 4 Mk2 (On = I).
The Power LED and all activated switches light up.

Power off

Switch off the power switch on the rear panel of the Transient Designer 4 Mk2 (Off = O).
The Power LED and all activated switches will no longer light up.
2