Thera-Assist Exercising Software - MEDICA THERA-vital Gebrauchsanweisung

Get-in-support
You can use the get-in-sup-
port to move each pedal to
an easy position for getting
the feet in.
❑
Press and release the button and wait until
the foot rest has moved to the easy entry
position (crank at lowest position).
❑
Place the first foot in the foot rest that is at
the bottom.
❑
Press the button again and wait for the
other foot rest to move to the easy entry po-
sition.
❑
Now secure the first foot in the foot rest at
the top and then place the second foot in
the foot rest at the bottom.
❑
Press the button again and wait for the foot
rests to reach the first position again. Now
secure the second foot.
Changing
the
session
time
When an exercising session is in progress,
two buttons for changing the session time are
shown at the bottom left and right of the
screen.
Pressing the + button increases the session
time. To increase the session time in one sec-
ond increments, press and release the button.
Pressing and holding the + or – button in-
creases/decreases the session time continu-
ously up/down to the maximum/minimum.
49
Start/Stop
When in stand-by mode, the THERA-vital is
activated by pressing any button. The screen
then lights up. Following a self-test lasting
about 5 sec. the THERA-vital is ready for use.
Pressing the START button then starts an ex-
ercising session with the basic settings.
The exerciser starts at a speed of 10 rpm.
By actively turning the cranks at a speed
greater than that of the motor, you can
change over to active exercising at any time.
You can pause an exercising session in
progress by pressing the STOP button once
and resume it by pressing the START button.
Pressing the STOP button twice during an on-
going exercising session ends the session.
The display then shows the analysis for that
exercising session (see page 57).

THERA-assist exercising software

The THERA-vital (software version 01.04.00
or later) supports the THERA-assist software
for recording and documenting exercising
data as standard.
THERA-assist (Art. no. 06076-000) is availa-
ble as an optional feature. A detailed descrip-
tion of its functions is provided in the manual
supplied with the software package.