Control Pad With Colour Display - MEDICA THERA-vital Gebrauchsanweisung

Control pad with colour display

The colour display always shows all important settings and exercising session data. The basic start screen view shows the following information:
Resistance level (see page 48): shows the
exerciser resistance level on a scale from
1 - 15 or the set power level from 0 - 80
watts. You can change the setting before or
during the exercising session by pressing
the + and – buttons.
Anti-spasm function (see
page 48): this is active if the
symbol is solid red or inactive if
the symbol is white.
The button next to the symbol
changes the setting.
Leg/Upper torso trainer selector
(see page 48). The active option is
shown.
Change the setting as required be-
fore starting the training session
press the button next to the sym-
bol. Only possible if an upper torso
trainer is fitted.
Stops the exercising session
(see page 49)!
Pressing once pauses the exer-
cising session. Pressing a sec-
ond time ends the exercising
session and displays the analy-
sis for the last session.
Power output: only shown
when exercising actively; in-
dicates power output in
watts (Neuro mode) or en-
ergy consumption in kcal
(Ortho mode).
Status bar
Remaining session time
47
Pulse rate, shows the heart rate and a heart symbol that is at least
partially coloured red when the heart rate monitor is connected and
supplying a good heart rate signal. When the heart symbol is col-
oured completely red, the heart rate signal is the optimum strength.
If the heart symbol is grey, no heart rate monitor is connected.
Distance completed
Speed (see page 48): when exer-
cising actively shows the actual
speed of rotation of the cranks;
when exercising actively-assisted
shows the preset speed, which is
the speed of the motor.
Press the + and – buttons to alter
the setting.
Direction of rotation (see
page 48)
Change the setting before or dur-
ing an exercising session by
pressing the button next to the
symbol.
Get-in-support (see page 49).
Activate/deactivate get-in-sup-
port mode by pressing the button
next to the symbol.
If get-in-support mode is active
the symbol is green.
Starts the exercising session
with an initial speed of 10 rpm
and starts recording a new ses-
sion analysis (see page 49).