Connection Of The Towing Coupling Electric Installation Harness In The Luggage Compartment - Skoda Roomster 5J7 Montageanleitung

Running through the electric installation harness
- 2 -
- Description of electric installation harness of the towing coupling in the car.
- 3 -
GB
- Release the bottom bushing of the opening for running the electric installation through on
the rear front of the car.
- 4, 5 -
- Run the complete towing coupling electric installation harness (A) through the opening into
the trunk. Close the opening with the bushing which is included in the towing coupling
electric installation harness.
- Snap the towing coupling electric installation harness terminal boards in the socket guard
(E).
- Seat the assembly on the towing coupling socket holder according to the figure and screw
down with three screws located in the socket guard. Tighten the screws with tightening
torque of 3 Nm.
Connection of the towing coupling electric installation harness in the
luggage compartment
- 6a, 7a, 8a - applies for vehicles Škoda Roomster (5J7)
- Lead the towing coupling electric installation harness (A) in the left (in the direction of the
drive) alongside the luggage compartment threshold towards the left rear wheel housing.
- On the rear wheel housing, run the towing coupling electric installation harness -arrow-
under the existing electric installation of the vehicle and lead it in parallel with it, up to the
strut for fixing the rear seats.
- Run the harness under the carpet alongside the strut for fixing the rear seats, up to the cen-
tral tunnel of the car bodywork (Fig. 8).
- Tighten the towing coupling electric installation using the tightening tapes (J) and fasteners
(K), as shown on the pictures. On the rear wheel housing, fasten the towing coupling electric
installation harness into the Škoda fasteners.
- 6b - applies for vehicles Škoda Praktik (5J8)
- Lead the towing coupling electric installation harness (A) in the left (in the direction of the
drive) alongside the luggage compartment threshold towards the left rear wheel housing. At
this point, slide the protective bellows (M
installation.
- On the rear wheel housing, run the towing coupling electric installation harness in parallel
with the existing electric installation of the vehicle up to the strut for fixing the rear seats.
Slide the protective bellows (M
lation harness.
- Then run the harness under the carpet alongside the strut for fixing the rear seats, up to the
central tunnel of the car bodywork, as in vehicles Škoda Roomster (5J7).
- 550 mm length) on the towing coupling electric
1
- 1380 mm length) on the towing coupling electric instal-
2