Troubleshooting - Stihl TSA 230 Gebrauchsanleitung

English
Sound pressure 103 dB(A)
level L according
peq
to EN 60745-2-22:
Vibration level a
hv,eq
according to
EN 60745-2-22:
Handle, left:
3.5 m/s
Handle, right
3.5 m/s
21.5.2 Values when maximum engine speed
without load with diamond cutting
wheel
Sound pressure 93 dB(A)
level L according
peq
to EN 60745-2-3:
Sound power level 104 dB(A)
L according to
w
EN 60745-2-3:
21.5.3 Values when maximum engine speed
without load with composite resin cut‐
ting wheel
Sound pressure 72 dB(A)
level L according
peq
to EN 60745-2-3:
Sound power level 83 dB(A)
L according to
w
EN 60745-2-3:
The sound and vibration levels indicated were
measured according to a standardized test
method and can be used as a basis for compar‐
ing electric power tools. The actual sound and
vibration levels may vary from the values indica‐
ted, depending on the type of application. The
sound and vibration levels indicated can be used
for an initial estimate of the sound and vibration
stress. The actual sound and vibration stress has
to be estimated. The times can be taken into
account in the estimate when the electric power
tool is switched off and also when it is switched
on but running without any load.
For information on compliance with the Vibration
Directive 2002/44/EC, visit

22 Troubleshooting

Always remove the battery before carrying out any work on the power tool.
Fault
Power tool does not run when
switched on
58
2
2
Cause
No electrical contact between
power tool and battery
Battery charge state is too low
(1 LED on battery flashes
green)
Battery too hot / too cold
(1 LED on battery is red)
www.stihl.com/vib
The K‑factor in accordance with Directive
2006/42/EC is 2.0 dB(A) for the sound pressure
level and sound power level; the K‑factor in
accordance with Directive 2006/42/EC is
2
2.0 m/s for the vibration level.
21.6 Transporting
STIHL rechargeable batteries comply with the
requirements stipulated in UN‑Manual Tests and
Criteria, Part III, Subsection 38.3.
The user can transport STIHL rechargeable bat‐
teries by road without additional conditions to the
place where the machine is to be used.
The lithium ion batteries included are subject to
the provisions of hazardous goods law.
When shipped by a third party (e.g., air transport
or a shipping company), special packaging and
identification requirements must be followed.
When preparing the item for shipment, a hazard‐
ous goods expert must be consulted. Please
comply with any additional national regulations.
Pack the rechargeable battery so that it cannot
move inside the packaging.
For additional transportation instructions, see
www.stihl.com/safety-data-sheets
21.7 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorization and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation (EC) No. 1907/2006 see
www.stihl.com/reach
Remedy
Remove battery, visually
inspect the contacts and rein‐
sert the battery
Charging the battery
Let the battery cool down / let
the battery warm up gradually
22 Troubleshooting
0458-707-9821-C